Lubrication - Yamaha Vector RS90RX Owner's Manual

Periodic maintenance
5. Adjust the drive track deflection to speci-
fication.
Drive track More than
deflection specified
Left adjusting
nut
Right adjust-
ing nut
ECS00591
CAUTION:
The right and left adjusting nuts should be
turned an equal amount.
6. Recheck alignment and deflection. If nec-
essary, repeat steps 3 to 5 until the prop-
er adjustment is achieved.
7. Tighten the rear axle nut.
Rear axle nut tightening torque:
75 Nm (7.5 m·kgf, 54 ft·lb)
Slide runners
Check the slide runners for wear and dam-
age.
If the slide runners reach the wear limit, they
should be replaced.
1. Slide runner
2. Wear limit height
Slide runner wear limit height:
10.5 mm (0.41 in)
62
Less than
specified
Turn in Turn out
Turn in Turn out
ECS00350
CAUTION:
Ride on fresh snow frequently. Operating
on ice or hard-packed snow will rapidly
wear the slide runners.
ESU12190

Lubrication

Lubricate the following points with the speci-
fied grease.
EWS00510
WARNING
Apply a dab of grease onto the cable end
G
only. Do not grease the throttle cable be-
cause it could become frozen, which
could cause loss of control.
Be sure to have a Yamaha dealer lubri-
G
cate the front and rear suspensions.
Lubricant:
Low-temperature grease
1. Throttle cable end