Yamaha Vector RS90RX Owner's Manual page 47

1. Fastener
2. Right side cover
1. Fastener
2. Left side cover
To install a side cover
1. Place the side cover in the original posi-
tion, and then tighten the fasteners.
2. Install the shroud.
NOTE:
Be sure to fit the projection on the rear of the
side cover into the hole in the lower side cov-
er.
Top cover
To remove the top cover
1. Remove the shroud. (See the above pro-
cedure.)
2. Remove the screws, and then remove
the cable guide.
Periodic maintenance
1. Screw
2. Cable guide
3. Loosen the quick fastener screws, dis-
connect the main switch coupler and aux-
iliary DC jack coupler (RS90GT /
RS90GTA / RS90LTGT), and then re-
move the top cover.
1. Quick fastener screw
2. Top cover
To install the top cover
1. Connect the main switch coupler and
auxiliary DC jack coupler (RS90GT /
RS90GTA / RS90LTGT), place the top
cover in the original position, and then
tighten the quick fastener screws.
2. Pass all of the cables, etc., through the
cable guide, place the cable guide in the
original position, and then install the
screws.
3. Install the shroud.
41