4-26) Compressor - Samsung RF18A Series Service Manual

DISASSEMBLY AND REASSEMBLY

4-26) Compressor

Part Name
1. Sand Paper Process
- Use the Sand Paper to make the left part of
the weld metaled metal smooth.
- Use the Sand Paper to make the right part of
the welded metal smooth.
2. Pipe Cutting Process
- Using the pipe cutter, cut both welded parts.
Compressor
(Straight section should be at least 25mm)
3. Connect, Suc. Bending process - Bend
Connect, and Suc. to make a straight line with
the Comp Pipe.
(Make sure Connect, and Suc. do not interrupt
the Fan after the Bending process)
This appliance contains a small amount of isobutane refrigerant (R-600a), a natural gas with high environmental
compatibility that is, however, also flammable. When transporting and installing the appliance, care should be taken to
ensure that no parts of the refrigerating circuit are damaged.
CAUTION
4. Check Service Ring specifications of the Pipe
Compressor
5. Applying Lokprep and connecting the Service
Ring_1 - Before applying Lokprep, remove any
foreign substances on the pipe surface with
Sand Paper- Apply 0.05g of Lokprep onto the
Comp Pipe- Insert the Service Ring in the Comp
Pipe and fasten it by screwing it 360° 2 times.
This document cannot be used without Samsung's authorization.
How To Do
When disassembling, make sure the unit turned off.
If you want to assembly, follow the reverse order.
57
Descriptive Picture
NG
OK