Maintenance - Dremel 6700 Operating/Safety Instructions Manual

DM 1619PA7491_06-14_6700 6/26/14 11:46 AM Page 16
Service
Tool service must be
W RNING
performed only by qualified
repair personnel. Service or maintenance
performed by unqualified personnel may result
in misplacing internal wires and components
which could cause serious hazard.
To
W RNING
unexpected starting or
electrical shock, always remove plug from
wall outlet before performing service or
cleaning.
CARBON BRUSHES
The brushes and commutator in your tool
have been engineered for many hours of
dependable service.
In order to prepare your brushes for use, run
your tool at full speed for 5 minutes under no
load. This will properly "seat" your brushes,
which extends the life of both your brushes
and your tool.
Excessive sparking is a sign of worn out
carbon brushes. Your brushes can be
replaced by an authorized Dremel Service
Center.
Use only recommended accessories. follow instructions that accompany
W RNING
accessories. Use of improper accessories may cause hazards.

Maintenance

avoid injury from
Accessories
BEARINGS
Model 6700 has ball bearing construction.
Under normal use no additional lubrication is
required.
Cleaning
To avoid accidents always disconnect the
tool from the power supply before
cleaning or performing any maintenance.
The tool may be cleaned most effectively
with compressed dry air. Always wear
safety goggles when cleaning tools with
compressed air.
Ventilation openings and switch levers must
be kept clean and free of foreign matter. Do
not attempt to clean by inserting pointed
objects through openings.
Certain cleaning agents and solvents
damage plastic parts. Some of these are:
gasoline, carbon tetrachloride, chlorinated
cleaning solvents, ammonia and house hold
detergents that contain ammonia.
16