Network Firmware - Canon imageFORMULA DR-G2140 Service Manual

5) After the firmware is upgraded, all tabs ex-
cept the firmware disappear to prevent op-
eration mistakes of the service tool.
Figure 5-271
6) Restart the service tool and scanner main
body and then check the version number.
 For unregistered firmware
In this mode, the file saved in the software
is selected and its version is upgraded.
1) Select [Version up] in upper side.
Figure 5-272
2) When the file selection screen is displayed,
select the file.
3) Writing starts automatically and the pro-
gress screen is displayed.
The rest of the procedure is the same as
in "For registered firmware".
Note: This automatically detects whether the
file is for the connected scanner and
only executes writing if it is suitable.
COPYRIGHT © CANON ELECTRONICS INC. 2018

3. Network Firmware

This is used to upgrade the firmware for
the network related. This file is supplied by
"bin" format.
Note: Do not remove the USB cable or turn
the power OFF during loading. If the
power is turned OFF, it returns to its
original state when restarted, but his is
not guaranteed.
 Operation Procedure
1) Select [Version up] in lower side.
2) When the file selection screen is displayed,
select the file.
3) Writing starts automatically and the pro-
gress screen is displayed.
The rest of the procedure is the same as
in "For registered firmware".
Note: This automatically detects whether the
file is for the connected scanner and
only executes writing if it is suitable.
4) Restart the service tool and scanner main
body and then check the version number.
CANON DR-G2140/G2110/G2090 FIRST EDITION
CHAPTER 5 TROUBLESHOOTING
Figure 5-273
5-35