Calling Another Station (Direct Voice Call) - Aiphone IS-SOFT Operation Manual

Calling another station (direct voice call)

Follow the steps below to call a desired door station, room sub
station or master station in your site, or remote site.
1 Search for and select the station or remote site you
want to call (so that it is highlighted) in one of the
search methods. (→P. 21-24)
If you call (the pilot station in) a remote site by searching
*
for it from [REMOTE SITE] of SEARCH LIST, select
the target site, and then select [CALL] (so that it is
highlighted). (→P. 23)
Refer to the on-screen instructions:
Be sure to make operations by checking the information on the
upper part of the list area. The next operations you can perform
are displayed.
e.g.)
[ ] TALK ... You can start talking by clicking
* If you will not set the priority, it is set to
"Normal".
[ ] MONI ... You can start monitoring by clicking
[ ] PR (or PRIORITY)
......... You can proceed to the priority setting
mode by clicking
2
To set the priority, click
select the target priority (so that it is highlighted).
If yo u will not set the priority, skip this step and click
*
. You can start calling (talking) with "Normal" priority.
.
.
.
, and then click to
3
Click or to start calling (talking).
or
When a tone rings, your voice is heard at the target station
and you can also hear sounds at the target station. (Direct
voice call)
The receiver can answer the call without pressing any
button or lifting the handset. (Talk back)
If the target station is a (PC) master station, the
*
response of it differs from the PRIVACY mode setting on
the target station. (See the table below.)
PRIVACY mode
setting on the target
master station
Your voice is heard at the target
OFF station and you can also hear sounds
at the target station.
Communication is enabled when
the receiver makes an answering
1
operation. Otherwise you can hear no
sound from the target station.
When the target station receives your
call, a tone notifi es you that the target
station is in the "Privacy 2" mode.
Communication is enabled when
the receiver makes an answering
2 operation. Otherwise you can hear no
sound from the target station.
* You can adjust the volume of call
4 Click to fi nish communicating.
Response
tone by using the speaker volume
adjusting slider in the volume
control window.
25