Table of Contents
Advertisement
1.
Press the learn button on the garage
door opener motor, you have 30
seconds to complete the next two
steps.
2. Return to your vehicle.
E188212
3. Press and hold one of the three
HomeLink function buttons you want
to program for two seconds, then
release. Repeat this step. Depending
on your brand of garage door opener,
you may need to repeat this sequence
a third time.
PROGRAMMING THE GARAGE
DOOR OPENER TO YOUR GATE
OPENER MOTOR
Gate Operator / Canadian
Programming
Canadian radio-frequency laws require
transmitter signals to "time-out" (or quit)
after several seconds of transmission –
which may not be long enough for
HomeLink to pick up the signal during
programming. Similar to this Canadian law,
some U.S. gate operators "time-out" in the
same manner.
Note: If programming a garage door opener
or gate operator, it is advised to unplug the
device during the "cycling" process to
prevent possible overheating.
2022 Expedition (TB8) Canada/United States of America, enUSA, Edition date: 202109, First-Printing
Garage Door Opener
1.
2. Release the hand-held transmitter
3. Press and hold the HomeLink function
Note: If the indicator light stays on, the
programming is complete.
Note: If the HomeLink indicator flashes
rapidly, repeat Step 3.
Note: If your device still does not operate,
you must program your garage door. See
Programming the Garage Door Opener to
Your Garage Door Opener Motor (page
172).
4. To program additional buttons, repeat
CLEARING THE GARAGE DOOR
OPENER
1.
173
Press and release, every two seconds,
your hand-held transmitter until the
HomeLink indicator light changes to a
rapidly blinking or continuously on light.
button.
button you want to program for two
seconds, then release. You may need
to do this twice to activate the door.
Steps 1 – 4.
E188213
Press and hold the outer two function
buttons simultaneously for
approximately 10 seconds until the
indicator light above the buttons
flashes rapidly.
Advertisement
Table of Contents
Troubleshooting
