Using The Automatic Thread Cutting Function (End Color Trim) - Baby Lock Solaris 2 Instruction And Reference Manual

■ Bobbin Thread is Too Loose
Bobbin thread appears slightly on the right side of
fabric.
a Right side
b Wrong side
If this occurs, turn the slotted screw (-) clockwise,
being careful not to over-tighten the screw,
approximately 30-45 degrees to increase bobbin
tension.
■ Bobbin Thread is Too Tight
Upper thread on the right side of fabric seems to be
lifting/looping and bobbin thread is not seen on the
wrong side of fabric.
a Right side
b Wrong side
If this occurs, turn the slotted screw (-)
counterclockwise, being careful not to over-loosen
the screw, approximately 30-45 degrees to decrease
bobbin tension.
CAUTION
• When adjusting the alternate bobbin case, be
sure to remove the bobbin from the alternate
bobbin case.
• DO NOT adjust the position of the phillips (+)
screw on the alternate bobbin case as this may
result in damage to the bobbin case, rendering
it unusable.
• If the slotted screw (-) is difficult to turn, do
not use force. Turning the screw too much or
providing force in either (rotational) direction
may cause damage to the bobbin case. Should
damage occur, the bobbin case may not
maintain proper tension.
MAKING EMBROIDERY ADJUSTMENTS
Using the Automatic Thread
Cutting Function (End Color
Trim)
The automatic thread cutting function
cut the thread at the end of embroidering each
color. This function is initially turned ON. To turn
this function OFF, press
* This setting returns to its default
machine is turned off.
a
Press .
b
Press to turn off the automatic thread
cutting function.
 The key will display as
* When one color thread is embroidered, the machine
will stop without cutting the thread.
will
key and then .
when the
.
101
3