Parameters; Station Mode; Parameter List - Mitsubishi Electric MELSERVO MR-MT2010 Instruction Manual

9. PARAMETERS

9. PARAMETERS
CAUTION

9.1 Station mode

9.1.1 Parameter list

Never make a drastic adjustment or change to the parameter values as doing so
will make the operation unstable.
Do not change the parameter settings as described below. Doing so may cause
an unexpected condition such as failing to start up the sensing module.
Changing the values of the parameters for manufacturer setting
Setting a value outside the range
Changing the fixed values in the digits of a parameter
When writing parameters from the controller, check that the station number or
axis number of the sensing module is set correctly. If the set station number or
axis number is incorrect, the parameter setting values of a different station or
axis will be written, leading to unexpected operations of the sensing module.
POINT
When you connect the sensing module to a servo system controller, parameter
values of the servo system controller will be written to each parameter.
Setting may not be made to some parameters and their ranges depending on
the servo system controller model, sensing module, and MELSOFT MT Works2
software version. For details, refer to the servo system controller user's manual.
Check the software version of the sensing module using MELSOFT MT Works2.
POINT
The parameter whose symbol is preceded by * is enabled with the following
conditions:
*: After setting the parameter, cycle the power or reset the controller.
**: After setting the parameter, cycle the power.
9 - 1