Table of Contents
Advertisement
3
BIOS Setup
Wake-Up By PCI Card
Enabled
Disabled
Power On By Ring
Set this field to Enabled to use the modem ring-on function. This will
allow your system to power-on to respond to calls coming from an
external modem.
Wake Up On LAN
If you are using a LAN card that supports the remote wake up
function, set this field to Enabled. The will allow the network to
remotely wake up a Soft Power Down (Soft-Off) PC. However, if
your system is in the Suspend mode, you can wake up the system
only through an IRQ or DMA interrupt. Refer to "Wake-On-LAN
Connector" in chapter 2 for more information.
USB KB Wake-Up From S3
This field, when enabled, allows you to use a USB keyboard or USB
mouse to wake up a system that is in the S3 (STR - Suspend To
RAM) state. This can be configured only if the "ACPI Suspend Type"
field is set to "S3(STR)".
84
This field should be set to Enabled only if your PCI
card such as LAN card or modem card uses the PCI
PME (Power Management Event) signal to remotely
wake up the system.
card will cause the system to wake up.
card's documentation for more information.
The system will not wake up despite access to the PCI
card.
Access to the LAN card or PCI
Refer to the
Advertisement
Table of Contents
