Table of Contents
Advertisement
2
Hardware Installation
IrDA Connector
Connect your IrDA cable to connector J17 on the system board.
BIOS Setting
Set the "Serial Port 1 Mode" field in the Integrated Peripherals
submenu ("Super IO Device" section) of the BIOS to the type of
IrDA standard supported by your device.
Driver Installation
You may need to install the proper drivers in your operating system
to use the IrDA function. Refer to your operating system's manual or
documentation for more information.
52
Note:
The sequence of the pin functions on some IrDA cable may be
reversed from the pin function defined on the system board.
Make sure to connect the cable to the IrDA connector
according to their pin functions.
IRRX
N. C.
Ground
VCC
IRTX
1
5
Advertisement
Table of Contents
