Table of Contents
Advertisement
IDE HDD Block Mode
Enabled The IDE HDD uses the block mode. The system BIOS
will check the hard disk drive for the maximum block
size the system can transfer. The block size will depend
on the type of hard disk drive.
Disabled The IDE HDD uses the standard mode.
Onboard Device
Move the cursor to this field and press <Enter>. The following
screen will appear.
The settings on the screen are for reference only. Your version may not be identical
to this one.
USB Controller
This field is used to enable or disable the USB ports.
USB 2.0 Controller
If you are using USB 2.0, this field must be set to Enabled.
USB Keyboard Support
If you are using a USB keyboard under DOS, set this field to
Enabled.
3
BIOS Setup
75
Advertisement
Table of Contents
