Table of Contents
Advertisement
Chassis Open Connector
Ground
Chassis signal
The system board supports the chassis intrusion detection function.
Connect the chassis intrusion sensor cable from the chassis to J2.
Whenever a chassis component has been removed, the sensor
sends signal to J2 alerting you of a chassis intrusion event.
Hardware Monitor for Windows
Install the "Hardware Monitor for Windows" utility. By default, the
chassis intrusion detection function is disabled. When enabled, a
warning message will appear when the chassis is open. The utility can
also be configured so that a beeping alarm will sound when the
chassis is open. Refer to the "Hardware Monitor for Windows"
section in chapter 4 for more information.
1
2
Hardware Installation
2
55
Advertisement
Table of Contents
