Table of Contents
Advertisement
4-2. Removal/Installation of Cabinet
4-2. Removal/Installation of Cabinet
4-2-1. Front Panel Removal/Installation
n
Be sure to put on the earth-band to establish a ground when
removing/installing the front panel during the power on.
If not, this may cause malfunction.
1. Loosen the four screws (with stoppers) on the front
panel.
2. Remove the front panel while pushing the panel
brackets between the ornamental panel and front panel
(B).
Front panel
RK
4 x 20
Panel brackets
3. For installation, perform the removal procedures in
reverse order.
4-2 (E)
RK4 x 20
Ornamental panel
Front panel (B)
Panel bracket
4-2-2. Cover Removal/Installation
1. Remove the four screws (each two screws at the right
and left), and remove the rack angles of both sides.
2. Remove the 12 screws (three screws for one handle),
and remove all handles of both sides.
Handle
RK4 x 6
B4 x 8
Rack
angle
3. Remove the eight screws, and remove the cover while
winding both sides of the cover.
B4 x 6
4. For installation, perform the removal procedures in
reverse order.
Handle
RK4 x 6
B4 x 8
Rack angle
B4 x 6
Cover
B4 x 6
VSR-2000
Advertisement
Table of Contents
