Table of Contents
Advertisement
2-3. Upgrading the BOOT OS
2-3. Upgrading the BOOT OS
This section describes how to upgrade the BOOT OS by entering commands.
1. FSE BOOT OS
1. S301-1/SY-283 board → OFF
2. Remove the front panel. (Refer to Section 4-2-1.)
3. Turn on the power.
4. Connect the VSR-2000 to a personal computer and set the communication rate. (Refer to Section 2-1.)
5. Set the service port selector switch to "0".
6. Activate Tera Term and set the communication rate. (Refer to Section 2-1.)
7. Press the [ENTER] key.
("MON>" is displayed.)
8. Enter "FLASH 1 ERASE BOOT"
(The software in the old version is erased.)
9. Enter "FL 1".
("Load Mode" is displayed.)
10. Select "File" _ "Sendfile" from the top menu.
11. Select the file "bmon1.mot" to be downloaded.
12. Downloading is executed.
c
Never touch the screen until downloading is completed.
If downloading is interrupted because of touching the screen, repeat steps 8 and later.
13. After downloading is completed, "OK" is displayed.
14. Enter "RES" and confirm that a message is displayed on the screen.
(The program in a new version is executed.)
15. Turn off the power.
16. S301-1/SY-283 board → ON
17. Turn on the power.
18. Set the service port selector switch to "1".
19. Activate Tera Term.
20. Press the [ENTER] key.
("FSE>" is displayed.)
21. Enter "q".
("MON>" is displayed.)
22. Enter "RES" and confirm that a message is displayed on the screen.
(The program in a new version is executed.)
2-10 (E)
VSR-2000
Advertisement
Table of Contents
