Program Preset Position; Call Preset Position - Panasonic WJ-SX150 Operating Instructions Manual

Program Preset Position

1. Select the desired monitor and camera. (Refer to p. 90
Monitor Selection and p. 91 Camera Selection.)
2. To move the camera to the position to be preset, move
the joystick and press the lens control buttons.
3. To select the desired preset position number, press the
numeric buttons.
4. When you have selected a wrong number, press the
CLEAR button to clear the numeric input.
4. Press the CALL PRESET button while holding down the
SHIFT button to save a preset position of the selected
camera.
TOUR SEQ
T&D
STILL
NEXT
MON STATUS
EL-ZOOM
PAUSE
ALM H
PAUSE SEQUENCE
MON (ESC)
MON LOCK
SHIFT
Notes:
• If the entered position number has stored the previ-
ous preset position, it will be overwritten by the new
one.
• SETUP MENU
Console can configure each operator's pan/tilt con-
trol. (Refer to p. 62 OPERATOR REGISTRATION or
p. 75 Operator Registration.)
93
CALL
PRESET
CAM ID EVENT
AUX1 OFF AUX1 ON PROGRAM
PRESET
ALL
AUTO PAN
AUX2 OFF AUX2 ON
VLD H SYS S
CAM FUNC
DEF OFF DEF ON
CAM (SET) CLEAR
LOG OUT
WIPER
MULTI SCREEN SEL
and WJ-SX150 Administrator

Call Preset Position

1. Select the desired monitor and camera. (Refer to p. 90
Monitor Selection and p. 91 Camera Selection.)
2. To select the desired preset position number, press the
numeric buttons.
4. When you have selected a wrong number, press the
CLEAR button to clear the numeric input.
3. Press the CALL PRESET button to move to the preset
position of the selected camera on the active monitor.
T&D CAM ID
AUX1 OFF
STILL
MON STATUS ALL
AUX2 OFF
EL-ZOOM
ALM H VLD H
DEF OFF
SEQUENCE
MON (ESC)
MON LOCK
MULTI SCREEN SEL
Note: To use the above function, you must set the pre-
set position number for the camera.
CALL
PRESET
EVENT
AUX1 ON PROGRAM
PRESET
AUTO PAN
AUX2 ON
SYS S
CAM FUNC
DEF ON
CAM (SET)
CLEAR
LOG OUT
WIPER