Recorder - Panasonic WJ-SX150 Operating Instructions Manual

RECORDER

(Recorder Control):
Recorder window (p. 66)
MANAGEMENT
(Put to SX150):
Put a File to SX150 window (p. 67)
(Get from SX150):
Get a Configuration Data from SX150 window
(p. 68)
SEQUENCE
(Tour Sequence): Tour Sequence window
(Group Sequence): Group Sequence window
SCHEDULE
(Timer Event):
Timer Event window (p. 70)
(Camera Cleaning):
Camera Cleaning window (p. 71)
(Daylight Saving Time/Summer Time):
Daylight Saving Time/Summer Time window
(p. 71)
ALARM
(Alarm Mode):
Alarm Mode window (p. 72)
(Alarm Event):
Alarm Event window (p. 74)
(Alarm Port):
Alarm Port window (p. 74)
OPERATOR
(Operator Registration):
Operator Registration window (p. 75)
(Level Table):
Level Table window (p. 76)
(Monitor Selection):
Monitor Selection window (p. 76)
(Auto Login/Logout):
Auto Login/Logout window (p. 77)
SYSTEM
(Time & Date):
Time & Date window (p. 77)
(Cable Compensation/VD2/DATA):
Cable Compensation/VD2/DATA window (p. 78)
(Camera Title):
Camera Title window (p. 79)
(Data Port):
Data Port window (p. 81)
MULTIPLEXER
(Multiplexer Mode):
Multiplexer Mode window (p. 82)
(Multiplexer Title):
Multiplexer Title window (p. 84)
66
(p. 68)
(p. 69)
In addition, the main window has the following buttons.
(File Open):
Select Setup Data File window (p. 84)
(Account Manager):
Account Manager window (p. 85)
(Communication Port):
Communication Port window (p. 86)
(Panasonic):
Opens the version information window of WJ-
SX150 Administrator Console. Clicking on "OK"
button will close the window.
Notes:
• To reflect each configuration to the system, save the file
by pressing the SAVE button before closing the win-
dow. After that, be sure to put the file from the PC to
the unit.
• When "No" is selected for Built in Multiplexer board in
the Recorder (refer to p. 66) window, you can open nei-
ther the Multiplexer Mode nor the Multiplexer Title win-
dow. Instead, a message window will appear and ask
you to select "Yes". When the Multiplexer board is
installed in the unit, select "Yes".
Recorder
This window configures the recorder setting parameters:
whether the multiplexer board is installed in the unit, what is
the type of the recorder, what is the recorder unit address,
and whether the gen-lock is activated.
How to Display
To display this window, click on the
button in the main window (p. 65).
Parameters
Built in multiplexer board: Click on the desired radio but-
ton.
Yes: Select this when the multiplexer board is installed in
the unit. If you select this, you can configure the
Multiplexer Mode window. (Refer to p. 82.)
No: Select this when the multiplexer board is not installed in
the unit.
The factory default setting is "No".
(Recorder Mode)