Panasonic WJ-HD200 Operating Instructions Manual page 62

8 Password Operation (PASSWORD OPERATION)
Enter a five-digit password to protect normal operations
from unauthorized access.
Available numerals: From 11111 to 88888
8 Keylock Buzzer (KEYLOCK BUZZER)
The buzzer will beep or not when a locked button is
pressed.
ON: Enables the buzzer beep.
OFF: Disables the buzzer beep.
8 Skip Alarm Recall (SKIP ALARM RECALL)
Specify the number of pages to be skipped in the alarm
log. The alarm log page will jump the specified pages
when the JogDial is rotated.
Available skip pages: 1, 5, 10, 20, 50
8 Simultaneous Recording and Playback
(SIMULTANEOUS REC&PLAY)
There may be cases where recording is essential while
playback is in progress.
ON: Allows both recording and playback at a time.
OFF: Allows exclusively recording or playback.
Note: The recording rate may be sacrificed in the fol-
lowing cases.
• Recording and playback/FTP access are carried
out simultaneously.
• A multi-split screen is displayed.
• VMD (video motion detection) is enabled.
• A PC accesses the live images via the network.
8 Alteration Detection (ALTER DETECT)
You can enable or disable the addition of alteration-
detection signals in the JPEG data supplied to the net-
work. The default is OFF.
ON: Detects alterations.
OFF: Does not detect.
Note: When set to ON, the data transmission rate on
the network will slow down.
8 Disk End Mode (DISK END MODE)
STOP: Stops recording until a mode other than [STOP]
is selected.
CONTINUE: Old data is automatically overwritten from
the disk start.
8 Disk End Buzzer (DISK END BUZZER)
ON: Enables the buzzer beep at the disk end (remain-
ing space = 0 %).
OFF: Disables the buzzer beep.
62
8 Play Priority (PLAY PRIORITY)
This setting places priority on a specific access point
for playing back the image data when access collisions
take place.
LOCAL: Places priority on front panel operations.
NET PLAY: Places priority on network access.
FTP GET: Places priority on access to the FTP.
NONE: The latest operation has priority over others.
8 Time Adjusting (TIME ADJUSTING)
The internal timer built into the WJ-HD200 is calibrated
once a day via the Time Adjust In and Out terminals on
the rear panel.
SLAVE: Accepts the calibration signal from the master.
MASTER: Supplies the calibration signal to the slave
units at the specified hour every day.