Table of Contents
Advertisement
• Simultaneous playback will pause prior to a time
space depending on the recording rate when the
playback area on the disk nears the recording area.
This is to avoid the access collision caused by the
simultaneous recording and playback in an area on
the disk.
0.1 FPS: 20 minutes maximum
1 FPS: 2 minutes maximum
7.5 FPS: 15 seconds maximum
15 FPS: 7 seconds maximum
• Even if preset to 30 or 15 FPS, the actual recording
rate may drop to 7.5 FPS at worst while busy multi-
tasks such as playback, remote-access playback,
remote-access live image, FTP access, multi-split
display, or video motion detection are carried out
simultaneously. The status display will indicate
"*→PLAY" while playing back the images recorded
with a rate different from the preset.
G Alteration Detection Setup
(ALTER DETECT)
You can enable or disable the recorder to add alteration-
detection signals in the JPEG data supplied to the network.
The default is OFF.
1. Move the cursor to ALT DET.
2. Select ON or OFF with the JogDial and press the
JogDial.
ON: Detects alterations.
OFF: Does not detect.
Note: When set to ON, the data transmission rate on
the network will slow down.
G Disk End Mode Setup
(DISK END MODE)
The menu offers the following options at the point where the
available recording space on the disk is used up: [STOP],
[CONTINUE]
DISK START
[STOP]
Restart
REC
DISK START
DISK START
[CONTINUE]
[Default]
DISK START
DISK END
Stop
REC
Waiting for a new entry
DISK END
DISK END
Overwritten automatically
DISK END
SYSTEM SETUP (1 OF 2)
PASSWORD LOCK
ALL→
OPERATION→
KEYLOCK BUZZ
SKIP ALM-RECALL
SIMUL REC&PLAY
ALTER DETECT
DISK END MODE
DISK END BUZZ
1. Move the cursor to DISK END MODE with the [D] or
[C] button.
2. Select the desired mode with the JogDial, and press
the JogDial.
The default is CONTINUE.
STOP: Stops recording until a new mode other than
STOP is selected.
CONTINUE: Old data is automatically overwritten from
the disk start.
Note: Remaining capacity will be displayed on the monitor
by turning the JogDial counter-clockwise in recording
mode when STOP is selected.
G Disk End Buzzer (DISK END BUZZ)
The buzzer can be set up to beep at the point where the
disk is full (remaining space 0 %). The setting is available
only when STOP is set for DISK END MODE.
1. Move the cursor to DISK END BUZZ with the [D] or [C]
button.
2. Rotate the JogDial to select the desired parameter.
The default is ON.
ON: Enables the buzzer beep at the disk end (remain-
ing space 0 %).
OFF: Disables the buzzer beep.
G Play Priority Setup (PLAY PRIORITY)
This setting places priority on a specific access point for
playing back the image data when access collisions take
place.
1. Move the cursor to PLAY PRIORITY.
2. Select an access point with the JogDial and press the
JogDial.
LOCAL: Places priority on front panel operations.
NET PLAY: Places priority on network access.
FTP GET: Places priority on access to the FTP.
NONE: The latest operation has priority over others.
OFF
*****
*****
OFF
1PAGE
ON
OFF
CONTINUE
ON
33
Advertisement
Table of Contents
