Panasonic WJ-HD200 Operating Instructions Manual page 30

G Disk Capacity Warning (HDD FULL)
The recorder monitors the disk capacity to warn the opera-
tor that the available capacity is nearing its end when STOP
is selected for DISK END MODE. There are two warning
levels. First, the FULL indicator on the front panel blinks
when the remaining capacity has reached the preset value.
Finally, the buzzer beeps when the disk is full, provided that
the DISK END BUZZER parameter in the SYSTEM SETUP is
set to ON. At the same time, the FULL indicator turns on.
DISPLAY SETUP
CLOCK→ JUN30.03
TIME&DATE
TIME&DATE DISP.ON
TIME&DATE POSI.R-LOWER
STATUS DISP.
STATUS POSI.
HDD FULL
REMOTE LED
HDD CHECK
CAMERA TITLEO
1. Select the desired value with the JogDial.
The default is 1 %.
1% - 99%: The FULL indicator blinks when the remain-
ing capacity reaches the selected value.
2. Press the JogDial (SET) to validate the selection.
3. Press the [D] or [C] button to select the next item, or
press the [SETUP/ESC] button to quit the display setup.
G Remote LED (REMOTE LED)
The remote LED on the front panel will indicate or ignore
the remote controlled status of the recorder via the network.
DISPLAY SETUP
CLOCK→ JUN30.03
TIME&DATE
TIME&DATE DISP.ON
TIME&DATE POSI.R-LOWER
STATUS DISP.
STATUS POSI.
HDD FULL
REMOTE LED
HDD CHECK
CAMERA TITLEO
1. Select either ON or OFF with the JogDial.
The default is OFF.
ON: REMOTE LED turns on when the network controls
the recorder.
OFF: REMOTE LED is deactivated.
30
15:05
TYPE1 24H
ON
R-LOWER
1%
ON
0:00
15:05
TYPE1 24H
ON
R-LOWER
1%
ON
0:00
2. Press the JogDial (SET) to validate the selection.
3. Press the [D] or [C] button to select the next item, or
press the [SETUP/ESC] button to quit the display setup.
G Disk Check (HDD CHECK)
S.M.A.R.T. (Self-Monitoring
Technology) is activated or deactivated for HDD check.
DISPLAY SETUP
CLOCK→ JUN30.03
TIME&DATE
TIME&DATE DISP.ON
TIME&DATE POSI.R-LOWER
STATUS DISP.
STATUS POSI.
HDD FULL
REMOTE LED
HDD CHECK
CAMERA TITLEO
1. Select either ON or OFF with the JogDial.
The default is OFF.
ON 0:00-23:00: The recorder checks the HDD at the
specified time every day.
OFF: Check is deactivated.
2. Press the JogDial (SET) to validate the selection.
3. Press the [D] or [C] button to select the next item, or
press the [SETUP/ESC] button to quit the display setup.
Note: Recording will resume after a one-second inter-
mission when HDD is checked.
G Camera Title (CAMERA TITLE)
Camera title and display position are specified for each
camera.
→
→
1. In the DISPLAY SETUP menu, move the cursor to CAM-
ERA TITLEO, and press the JogDial to open the CAM-
ERA TITLE menu.
2. Move the cursor to the camera you wish to program
using the [D] or [C] button.
Analysis and Reporting
15:05
TYPE1 24H
ON
R-LOWER
1%
ON
0:00