Table of Contents
Advertisement
G Time Adjust Setup
(TIME ADJUSTING)
IN and OUT terminals for a calibration signal are provided
on the rear panel. The master unit supplies the calibration
signal to the slave units once at the specified hour every-
day. The slave unit accepts the signal through the IN termi-
nal, and corrects its internal timer to the hour as far as the
clock deviates within 15 minutes after or before the hour.
This is convenient for synchronizing the internal clock with
other connected devices.
TIME ADJUST SETUP
TIME ADJUSTING
SET TIME→
1. Move the cursor to TIME ADJUST SETUPO in the SYS-
TEM SETUP with the [D] or [C] button, and press the
JogDial. The TIME ADJUST SETUP menu appears.
2. Select either MASTER or SLAVE with the JogDial, and
press the JogDial.
The default is SLAVE.
MASTER: The recorder supplies the calibration OUT
signal to the slave units.
SLAVE: The internal timer of the recorder is supplied
the calibration signal from the master.
3. Select the hour with the JogDial, and press the JogDial.
The hours: From 00:00 to 23:00
Note: You need not set the hour when SLAVE is select-
ed.
4. Press the [SETUP/ESC] button to go back to the SYS-
TEM SETUP menu.
34
SLAVE
9:00
G Auto Erasing Setup
(AUTO ERASING)
The redundant records on the disk can be erased every
day at 24:00 midnight. The number of days specified by
this setting stand for the number of days the records will be
protected from the present, while the records older than
that will be erased.
SYSTEM SETUP (2 OF 2)
PLAY PRIORITY
TIME ADJUST SETUP
AUTO ERASING
1. Move the cursor to AUTO ERASING with the [D] or [C]
button.
2. Select the desired number of days with the JogDial,
and press the JogDial.
OFF: Auto erasing is not applied.
1 DAY: Only today's records from 00:00 onward are
protected. Records before 24:00 yesterday are
erased.
2 to 10DAYS: Records before the specified number of
days are erased.
14, 30, 45, 60, 90, 120, 150, 180DAYS: Same as
above.
Notes:
• The number of days include today as 1 day, there-
fore 2DAYS covers today and yesterday.
• Auto erasing is implemented at 24:00 midnight.
Playback will stop once when the time reaches
24:00, then will restart with a different portion based
on the renewed day count.
LOCAL
O
OFF
Advertisement
Table of Contents
