Error Messages Reports - Panasonic KX-FP80 Operating Instructions Manual

KX-FP80 (054-061) 00.2.21
Error Messages
Reports!
If your unit cannot send a fax, check the following.
– The number you dialed is correct.
– The other party's machine is a facsimile.
If the problem remains, correct it by following the communication message printed on the
sending and journal reports (p. 28).
Communication message
COMMUNICATION ERROR
DOCUMENT JAMMED
ERROR-NOT YOUR UNIT
MEMORY FULL
NO DOCUMENT
OTHER FAX NOT RESPOND
PRESSED THE STOP KEY
THE COVER WAS OPENED
OK
54
9:43 AM Page 54
Error
code
40–42, A transmission or reception error occurred. Try
46–52, again or check with the other party.
58, 65,
68, 72,
FF
43, 44 An overseas transmission error occurred. Try using
the overseas mode (feature #23 on page 50).
— The document is jammed. Remove the jammed
document (p. 63).
54, 59, A transmission or reception error occurred
70 because of a problem with the other party's fax
machine. Check with the other party.
— The document was not received due to memory
being full.
— The document was not fed into the unit properly.
Reinsert the document and try again.
— The other party's fax machine was busy or ran out
of recording paper. Try again.
The document was not fed properly. Reinsert the
document and try again.
The other party's fax machine rings too many
times. Send a fax manually – dial the number,
confirm the fax tone, and press
The other party's machine is not a facsimile.
Check with the other party.
The number you dialed is not in service.
— STOP
canceled.
— The covers were opened. Close them and try
again.
— Fax communication was successful.
For fax advantage assistance, call 1-800-435-7329.
Cause & Remedy
FAX START
was pressed and fax communication was
.