Table of Contents
Advertisement
Rear Panel
* To prevent malfunction and equipment failure, always turn down the volume, and turn off all the units before making any connections.
8
9
13
12
14
8
DC IN jack
Connect the included AC adaptor to this jack.
* Route the cord of the AC adaptor through the grooves on the
bottom of the unit as shown in the illustration, to keep it in place.
* When turning the unit over, be careful so as to protect the buttons
and knobs from damage. Also, handle the unit carefully; do not
drop it.
9
ă (USB) port
Connect your computer or other device here to use this unit as
a USB audio interface, or for saving backups of device settings.
* Do not use a USB cable that is designed only for charging a device.
Charge-only cables cannot transmit data.
MEMO
This unit can be powered via the USB port.
A commercially available USB AC adaptor (5 V /3 A or greater)
is required to power this unit.
10
11
10
(Headphones 1) jack
Connect your headset or headphones here. Headsets can only
be used with headphones jack 1.
NOTE
Use a headset with a 3.5 mm CTIA-type mini plug (4-pole).
* Pin arrangement for mini cable (4-pole)
(Headphones 2) jack
Connect your headphones here.
11
(MIC) 1, 2 connectors
Connect your microphone(s) here.
About phantom power
*
You can supply phantom power (+48 V) from the Channel 1,
2 jacks (XLR). Turn on phantom power when you're using a
condenser microphone that requires phantom power.
Turn +48 V "ON" in the channel 1, 2 settings screen.
* Pin arrangement for the
1: GND
2: HOT
3: COLD
(INST) L, R jacks
Connect a keyboard or audio equipment here.
12
(MAIN OUT) L, R jacks
Connect these jacks to your amp, monitor speakers or mixer.
13
FOOT SW jack
You can control various functions with a footswitch (FS-5U/
FS-6/FS-7), an expression pedal (FV-500H/FV-500L/EV-30 or
Roland EV-5) or a foot controller (GA-FC) that's connected to
this unit.
* Use only the specified expression pedal. By connecting any other
expression pedals, you risk causing malfunction and/or damage
to the unit.
14
Ground terminal
Connect this to an external earth or ground if necessary.
Panel Descriptions
1, 2 connectors (XLR)
TIP:
HOT
RING:
COLD
SLEEVE: GND
L
R
GND
MIC
1: GND
3: COLD
3
Advertisement
Table of Contents
