Rear Panel - Boss ME-20 Owner's Manual

Names of Things and What They Do

Rear Panel

ME-20-rear-panel.eps_70
1
1. SECURITY LOCK (
http://www.kensington.com/
2. INPUT Jack
Connect your guitar here.
* The INPUT jack doubles as a power switch. Inserting a plug into the INPUT jack turns on
the power; the power is switched off when the plug is disconnected. Be sure to unplug the
cable from this jack when the ME-20 is not in use.
3. AUX IN Jack
Connect a CD or MP3 player here to practice with sounds from these devices.
* You cannot adjust the volume of the AUX input. Adjust the volume on the connected device.
* Do not use a cable that contains a resistor to connect external devices to the AUX IN jack.
Use of such cables may make sounds from connected devices inaudible.
* No effects are applied to the AUX input signal.
4. OUTPUT L/MONO, R Jacks
Connect an amp or mixer here.
5. PHONES (Headphones) Jack
Connect stereo headphones here.
When headphones are connected to the PHONES jack, tonal adjustments are
applied so the sound is close to that produced by the guitar amp.
6. FOOT SW (Footswitch) Jack
Connect an optional footswitch (such as the FS-6) here.
The footswitch functions differently in Manual mode and Memory mode.
When in Manual mode: Switches the OD/DS Solo on/off.
When in Memory mode: Bank up, Bank down
7. DC IN (AC Adaptor) Jack
Connect the optional AC adaptor (PSA series) here.
* Use only the specified AC adaptor (PSA series).
10
2
)
Switches the Bypass/Tuner on/off.
3 4 5 6 7