Rear Panel (Connecting Your Equipment) - Boss RC-600 Owner's Manual

Getting Ready

Rear Panel (Connecting Your Equipment)

To prevent malfunction and equipment failure, always turn down the volume, and turn off all the units before making any connections.
Pin assignment
MIC IN 1, 2 connectors
2: HOT 1: GND
3: COLD
Ground terminal
Connect this to an external earth
or ground.
Connect this if necessary.
7
MIC IN 1, 2 connectors
Connect your microphone(s) here.
* If you're using a condenser mic that requires phantom power, turn
on this unit's phantom power.
INST IN 1, 2 jacks (L/MONO, R)
Connect your guitar/bass, effect units, keyboards and other
instruments to these jacks.
8
MAIN OUTPUT jacks (L/MONO, R)
SUB OUTPUT 1, 2 jacks (L/MONO, R)
Connect these jacks to your amp, monitor speakers or mixer.
MEMO
You can set the MAIN/SUB jacks as parallel output jacks
(mono output x 6) that individually output the sounds from each
track.
& "Parameter Guide" (PDF)
PHONES jack
Connect your headphones here.
MEMO
You can configure this unit to let you listen to only the audio you
specify in headphones.
& "Parameter Guide" (PDF)
6
7 8 9 10
9 CTL/EXP
CTL 1, 2/EXP 1 jack and CTL 3, 4/EXP 2 jack
You can connect an expression pedal or footswitches
(sold separately) to these jacks, for controlling a variety of
functions.
* Use only the specified expression pedal (FV-500H, FV-500L, EV-
30, and Roland EV-5; sold separately). By connecting any other
expression pedals, you risk causing malfunction and/or damage
to the unit.
10
MIDI OUT, MIDI IN connectors
Connect an external MIDI device here.
This lets you control an external MIDI device from this unit via
MIDI.
11
USB port
Connect your computer using a commercially available USB cable
that supports USB 2.0.
You can connect your computer here and use it to back up or
recover data.
You can also use USB audio to play the sound from your computer
through this unit, and use USB MIDI to synchronize the tempo of
this unit with the DAW software on your computer.
[POWER] switch
Turns the power on/off.
DC IN jack
Connect the included AC adaptor to this jack.
* Use only the specified AC adaptor (PSB-1U), connected to an AC
outlet of the correct voltage.
11
To AC outlet