Downloading The Firmware From The Memory Card - Kyocera FS-1100 Service Manual

2H5/2HS

(1) Downloading the firmware from the memory card

To download data written in a memory card (CompactFlash) to the printer, proceed as explained in this section.
CAUTION
Downloading firmware takes several minutes. Do not turn power off during downloading. If downloading is interrupted by
an accidental power failure, etc., the control PWB may have to be replaced.
Do not download the system firmware and engine firmware at one time. Store the either firmware in a memory card and
download one by one.
Procedure
1. Turn printer power off.
2. Open the rear cover.
3. Remove two screws and then remove the
optional interface slot cover.
4. Insert the memory card into the memory
card slot.
1-6-2
All manuals and user guides at all-guides.com
Rear cover
Figure 1-6-2
Memory card slot
Memory card
Optional interface
slot cover
Figure 1-6-3
Screw
Screw