Kyocera FS-1100 Service Manual page 44
Hide thumbs
Also See for FS-1100:
- Service manual (168 pages) ,
- (109 pages) ,
- Operation manual (109 pages)
Table of Contents
Advertisement
2H5/2HS
Code
Contents
6400
Zero cross signal error
The zero cross signal does not reach the
control PWB for specified time.
F010
Control PWB checksum error
F020
Control PWB RAM checksum error
F030
Control PWB general failure
F040
Control PWB engine communication
error
F050
Control PWB engine checksum error
F226
Control PWB video data control error
1-4-8
All manuals and user guides at all-guides.com
Causes
Defective harness
between high volt-
age PWB (YC202)
and control PWB
(YC311), or
improper connec-
tor insertion.
Defective harness
between power
source PWB
(YC103) and high
voltage PWB
(YC201), or
improper connec-
tor insertion.
Defective power
source PWB.
Defective control
PWB.
Defective code
ROM (flash mem-
ory).
Defective control
PWB.
Defective main
memory (RAM) on
the control PWB.
Defective
expanded memory
(DIMM).
Defective control
PWB.
Defective control
PWB.
Some error may
have occurred
when downloading
the firmware of the
control PWB.
Defective control
PWB.
Defective control
PWB.
Remarks
Check procedures/corrective measures
Reinsert the connector. Also check for conti-
nuity within the connector harness. If none,
remedy or replace the harness (See page 1-
5-25).
Reinsert the connector. Also check for conti-
nuity within the connector harness. If none,
remedy or replace the harness (See page 1-
5-25).
Replace the power source PWB (See page
1-5-22).
Replace the control PWB (See page 1-5-
19).
Turn the power switch off/on to restart the
printer. If the error is not resolved, replace
the control PWB (See page 1-5-19).
Replace the control PWB (See page 1-5-
19).
Turn the power switch off/on to restart the
printer. If the error is not resolved, replace
control PWB (See page 1-5-19).
Replace the expanded memory (DIMM)
(See page 1-2-4).
Turn the power switch off/on to restart the
printer. If the error is not resolved, replace
control PWB (See page 1-5-19).
Turn the power switch off/on to restart the
printer. If the error is not resolved, replace
control PWB (See page 1-5-19).
Download the firmware of the control PWB
again using the memory card (See page 1-
6-2).
Turn the power switch off/on to restart the
printer. If the error is not resolved, replace
control PWB (See page 1-5-19).
Turn the power switch off/on to restart the
printer. If the error is not resolved, replace
control PWB (See page 1-5-19).
Advertisement
Table of Contents
