Setting The Lcd Language; Printing A Test Page From The Printer Panel; Adjusting The Color Density (Color Calibration) - Panasonic WORKIO DP-CL21 Setup Manual

Setup

Setting the LCD Language

• Select English, German, French, Spanish or Italian as
the language which is to appear on the LCD panel.
• English is the default language.
1
Press MENU/EXIT (PAUSE) button to enter the
Menu mode.
2
Press (CONTINUE) or
the Other menu appears.
3
Press ENTER button.
Language item menu appears.
4
Press ENTER button.
English selection menu appears.
5
Press (CONTINUE) or
the desired language is displayed.
6
Press ENTER button to activate your selection.
NOTE:
• Adhere the enclosed "Supplies Re-order Label" near the
printer's LCD panel to assist you in interpreting the
supplies related messages that may appear on the
printer's LCD display.
Printing a Test Page from
the Printer Panel
It is possible to confirm the printer's settings by printing a
configuration page.
1
Press MENU/EXIT (PAUSE) button to enter the
Menu mode.
2
Press (CONTINUE) button until Test Page menu
appears.
3
Press ENTER button.
Menu Map item menu appears.
4
Press (CONTINUE) button until Configuration
Page item menu appears.
5
Press ENTER button.
The printer will start printing a configuration page.
(CANCEL) button until
(CANCEL) button until
Adjusting the Color Density
(Color Calibration)
The printer panel provides an interface to adjust the
density of the toner applied to the media.
This feature compensates for the changes that can occur
as environmental conditions change, replacement of
accumulator unit and/or print cartridge.
Perform the following steps to adjust the color density:
1. Print a Color Calibration Test Print Page to confirm the
current density (Color Calibration) and compare it with
the provided Color Calibration Card.
2. If you wish to adjust the density for all colors
simultaneously, proceed to "Adjusting the Density
for All Colors Simultaneously".
OR
If you wish to adjust the density for each color
independently, proceed to "Adjusting the Density for
Each Color Independently".
Printing a Color Calibration Test Print
Page
1
Press MENU/EXIT (PAUSE) button on the printer
panel.
2
Press (CONTINUE) button until Color Calibration
menu is displayed.
3
Press ENTER button.
Calibration Offset item menu appears.
4
Press (CONTINUE) button until Calib. Test Prn.
menu is displayed.
5
Press ENTER button.
A Color Calibration Test Print Page will be printed.
• The current density setting for each color is
indicated by the line enclosure on the Color
Calibration Test Print Page as shown in the
following example.
29