Wire The Power Supply Using An M12-Terminated Cable (Optional) - Emerson Micro Motion 5700 Installation Manual

Power supply wiring
February 2023
5.2 Wire the power supply using an M12-terminated
cable (optional)
Use this procedure if you are using an M12-terminated cable to wire the power supply.
Prerequisites
Obtain an S-coded M12-terminated cable.
Procedure
1. Attach the M12-terminated cable to the power connector on the 5700 transmitter.
2. Attach the other cable end using the pinouts described in
40
Figure 5-2: M12-terminated cable to power supply
Note
For M12 power supply pinouts, only pins 1 and 3 are used.
Table 5-1: M12 power supply pinouts
Pin Wire color
identification
Pin 1 Brown
Pin 2 White
Pin 3 Blue
Pin 4 Black
Table
Outputs on board
Terminal 3
Terminal 1
Terminal 4
Terminal 2
Micro Motion 5700 Ethernet Transmitters
Installation Manual
MMI-20029768
5-1.
Signal name
VDC +
Channel B +
VDC -
Channel B -