Set up the printer
February 2023
7. Configure the printer type.
6.3
Reset the interface settings
Use this procedure if you forgot the IP address of your printer and need to reset the
default (192.168.192.168).
Procedure
1. Turn off the printer and close the roll paper cover.
2. If the connector cover is attached, remove the cover.
3. Hold down the status sheet button on the back of the printer while turning on the
4. Release the status sheet button to reset the printer settings to default.
6.4
Function Check Failed
A functional check alert is commonly triggered due to the following conditions:
•
Incorrect network settings configuration
•
Out of paper
•
Paper tray is open
•
Printer already has six open connections
•
Another transmitter tries to start a print while another transmitter is printing
configuration items and audit log tickets can take more than 15 minutes to print and
use up paper. If during this time another transmitter starts a print, the new print may
either be rejected, causing a functional check alert (printer offline), or the print will be
inserted in the middle of the configuration/audit log print.
44
a) Navigate to one of the following screens:
From the display
Go to Menu → Configuration → Ethernet
Settings → Network Settings → Subnet
Mask.
b) Set the subnet mask to
a) Navigate to one of the following screens:
From the display
Go to Menu → Configuration → Printer →
Printer Type.
b) Verify that the IP address is 192.168.192.168.
printer.
A message displays indicating that resetting is being performed.
Important
Do not turn off power until the process is complete.
When complete, a
Resetting to Factory Default Finished
displays.
From ProLink III
Go to Device Tools → Configuration →
Network Settings.
.
255.255.255.0
From ProLink III
Go to Device Tools → Configuration →
Printer and Tickets.
Micro Motion 5700 Ethernet Transmitters
Installation Manual
MMI-20029768
message