Chapter 2 Wiring; Wire Power; Wire Analog Outputs - Emerson Rosemount FCL-01 Reference Manual

Reference Manual
00809-0200-3412
2 Wiring
2.1

Wire power

Wire AC mains power supply to the power supply board, which is mounted on the left hand
side of the transmitter enclosure beneath the gray plastic cover.
WARNING
Electrical shock
Electrical installation must be in accordance with the National Electrical Code (American
National Standards Institute [ANSI]/National Fire Protection Association [NFPA]-70) and/or
any other applicable national or local codes.
Procedure
1. Unplug the connector from the board and wire the power cable to it.
2. Provide a switch or breaker to disconnect the transmitter from the main power
3. Install the switch or breaker near the transmitter and label it as the disconnecting
2.2

Wire analog outputs

Four analog current outputs are located on the main circuit board, which is attached to the
inside of the enclosure door.
Figure 2-1
polarity.
Rosemount FCL 56
Lead connections are marked on the connector. (L is live or hot; N is neutral; the
ground connection has the standard symbol.)
supply.
device for the transmitter.
shows the locations of the terminals, the outputs they are assigned to, and the
Wiring
October 2023
11