Installation; Subwoofer Level Control Installation - Clarion XC6 Series Owner's Manual & Installation Manual

Installation

1. Once a safe and suitable location has been chosen for your amplifier, remove both
top trim pieces from the amplifier using a 2mm hex driver. Store the four screws and
trim pieces in a safe location.
2. Locate the amplifier and mark the mounting hole locations.
3. Remove the amp and pre-drill the mounting holes.
4. Replace the amplifier and secure with adequate hardware.
5. Replace the upper trim panel and secure.
6. Make all the power, signal and speaker connections to the amp.
7. Complete the remainder of the installation and finish tuning the amplifier and system.
8. Install the lower trim panel and secure.

Subwoofer Level Control Installation

Clarion offers an remote subwoofer level control called the BC2 included in the box with
the XC6440 and XC6640 . When connected to the XC6440 or XC6640, it gives you the
ability to increase or decrease the output level of the associated channels to allow you to
fine tune the subwoofer level for the selection of music that is playing.
16
Remove all 5 of
these screws
Remote Level Control
Connection Point
Remote Level Control
Wire exits here