How To Connect/Disconnect The Data Line; Ip Handset Information - Furuno FELCOM501 Operator's Manual

3. SETTINGS FOR IP HANDSET
3.4.3

How to connect/disconnect the data line

You can connect or disconnect a data line of a WAN group to which IP Handset be-
longs. You can check with the Web interface to which group your IP Handset belongs.
Note 1: When Fleet Xpress mode is active, this menu is not available.
Note 2: Data communication is not available from the IP handset.
1. In the [Comm. Unit] menu, press
Enter key.
The [Data Line] screen appears.
2. Press
Enter key.
[Connect]: Enable data communication for the network equipment connected to
the same WAN group as this IP Handset.
[Disconnect]: Disable data communication for the network equipment.
3. Press the
Note: In some cases, it can take a few minutes to establish a data line connection.
3.5

IP Handset Information

You can check the system information and call restrictions for each IP Handset.
1. At the main screen, press the Enter key to open the main menu.
2. Press
The [Information] menu appears.
3-8
or to select [Disconnect] or [Connect] as appropriate, then press the
key to go back to the main screen.
, , or to select the [Info] menu, then press the Enter key.
to select the [Data Line] menu, then press the