AEG ABSOLUTECARE 9000 User Manual page 19

7.7 Finish in
Set this option as last after
programme and other
options selection, otherwise
it can be cancelled if you
change some setting.
This button allows activating the Finish in
option and by means of the Plus (+
increases) and Minus (- decreases)
touch buttons it is possible to choose the
time within which a programme should
terminate. The programme end can be
postponed by one 1 hour every + button
touch until 24 hours maximum. The
'finish in' time can be reduce by means of
the - button until 0.
The display shows the normal
programme duration alternatively with
the set programme end time (expressed
in hours 0h). The minimum selectable
time corresponds to rounded up hour of
the maximum duration of a programme
(e.g. if the cycle duration lasts 3:15
hours, the minimum selectable time will
be 4h).
After programme start, the door is locked
and the appliance starts the ProSense
phase. When load estimation ends, on
the display the icon of running phase
blinks and the time digit counts down in
steps of one hour and in steps of 1
minute during the last hour.
7.8 Start/Pause
Touch the Start/Pause
start, pause the appliance or interrupt a
running programme.
7.9 Plus Steam
This option adds a steam phase followed
by a short anti-crease phase at the end
of the washing programme.
The steam phase reduces fabric
creasing and facilitates the fabric ironing.
The Plus Steam option achieves good
results with a small load because steam
better penetrates the laundry if there is
more space. For this reason, the
programme maximum load combined
with this option is 2 kg (approximately 8 -
10 shirts).
When setting the Plus Steam option, the
maximum load drops to 2 kg in the
display and programme time is adjusted
accordingly.
The indicator
during steam phase.
When the programme stops the display
shows a zero
steady on.
The anti-crease phase starts, the
indicator
Pause
performs smooth movements for about
30 minutes to keep the steam benefit.
To interrupt the anti-crease phase, you
can:
• Press the On/Off button for a few
• Turning the programme dial in
When the anti-crease movements stop
and the door unlocks, the appliance
proposes again the previous set
programme.
button to 7.10 Extra Rinse
With this option you can add a few rinses
to the selected washing programmes and
optimise the fabric softener distribution
and improve the fabric softness.
It is suggested when you use the fabric
softener.
Useful for people allergic to detergents
and in areas where the water is soft.
This option increases the programme
duration.
The button indicator comes on.
blinks in the display
This option can affect the
programme duration.
, the indicator
is blinking, and the Start/
led remains lit. The drum
seconds to activate or the deactivate
the appliance.
another position.
A small laundry load helps to
reach better results.
ENGLISH 19
is