Page 1
Wasautomaat Lavadoras Aufstell- und Anschlußanweisung für Waschautomaten mit gewölbter Blende Installation and connection instructions for automatic washing machines with vaulted front cover Installation et raccordements des lave-linge à bandeau bombé Instruzioni di installazione e collegamento per lavatrici con pannello rigonfiato...
Important Safety Information The safety of AEG appliances is in accordance with recognised techno- logical standards and appliance safety legislation. We nevertheless feel that it is important to acquaint you with the following safety guide- lines. • This appliance is heavy, care should be taken when moving it.
Appliances with hot and cold water connections Hot water inlet Cold water inlet Appliance Installation The appliance worktop must not be removed to gain a height reduction when installing under a kitchen worktop. Appliance Transit • To prevent electrical components becoming wet when moving the appliance, do not tip the washing machine onto it’s front or the left hand side (viewed from the front).
Appliance Installation Removing Transit Packaging • Ensure all transit packaging is removed prior to installation. • Retain transit packaging for future use. The appliance is supplied with a spanner (H) and plastic caps (E) (2 pcs.) and (G) (1 pc). 0 Remove the hose holder (A).
Appliance Installation Installation-Site Preparation • The installation surface must be clean, dry and level. • Do not install on deep pile carpet. • If the appliance ist installed next to heat source (e. g. cooking appliance), a heat insulating pad (85 x 57 cm) must be placed between the washing machine and the heat source.
Electrical Connection Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. WARNING - THIS APPLIANCE MUST BE EARTHED. The manufacturer declines any liability should these safety measures not be observed. Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance rating plate.
Electrical Connection • The wire coloured green and yellow must be connected to the terminal marked with the letter “E“ or by the earth symbol coloured green and yellow. • The wire coloured blue must be connected to the terminal “N“ or coloured black.
Inlet Hose Connection The inlet hose provided is 1.2 or 1.3 metres depending on the model. If a longer inlet hose is required contact your AEG Service Force Centre. Under no circumstances should hoses be connected together to provide a longer length.
Page 11
0 Connect the hose to the machine with the right angled connector. IMPORTANT: Do not overtighten the plastic nuts on the threaded connectors. Rubber Washer 0 Connect the hose end with a straight connector to the water supply tap with an 3/4"...
Page 12
70°C. If only a cold water supply is available, connect the two hoses to the cold water outlet by means of a “Y“ connection piece. (A “Y“ piece is available from your AEG Service Force Centre, part number 645430709).
Longer drain hoses are available in lengths of 2.7 and 4 metres from your AEG Service Force Centre. If you intend the drain hose from the washing machine to...