OPERATION INSTRUCTIONS/FLAME APPEARANCE
is installed.
NOTE:
up and down.
the front and middle logs, but very little is necessary to cover this
orange and stringy. Apply just enough to obtain slow glow and a
patterns. Sooting and improper burning will result.
During manufacturing, fabricating and shipping, various components
These chemicals are not harmful, but may produce annoying smoke
and smells as they are burned off during the initial operation of the
appliance, possibly causing headaches or eye or lung irritation. This
is a normal and temporary occurrence.
The initial break-in operation should last 2-3 hours with the burner
at the highest setting. Provide maximum ventilation by opening
windows or doors to allow odors to dissipate. Any odors remaining
after this initial break-in will be slight and will disappear with
continued use.
Once the break in operation has been completed, adjust the
heater to the desired output and then replace the upper and lower
louvers.
26497-6-0511
attachment.
from inside burner box.
with brush. Failure to keep air intake hole clean will result in
sooting and poor combustion.
with vacuum or brush. Failure to keep air intake hole clean will
result in sooting and poor combustion.
intake holes.
up to the level of openings in burner top.
Page 31