Introduction - Empire Comfort Systems VFP28IN3 L Series Installation Instructions And Owner's Manual

Instructions to Installer
1. Installer must leave instruction manual with owner after
installation.
with unvented room heater.
3. Installer should show owner how to start and operate unvented
room heater.
Always consult your local Building Department regarding regulations,
codes or ordinances which apply to the installation of an unvented
room heater.
This appliance may be installed in an aftermarket* manufactured
*Aftermarket: Completion of sale, not for purpose of resale, from
the manufacturer.
This appliance is only for use with the type of gas indicated on the
rating plate. This appliance is not convertible for use with other
gases.
WARNING: ANY CHANGE TO THIS
CONTROLS CAN BE DANGEROUS.
Standard Z21.11.2 by the Canadian Standards Association
Laboratories as an Unvented Room Heater and should be installed
according to these instructions.
Any alteration of the original design, installed other than as
VFP28IN3 and VFP20IN3 Series Only
When you ignite the pilot, the thermocouple produces millivolts
After 30 seconds to 1 minute time period you can release the gas
gas control knob from the PILOT position to the ON position. This
All correspondence should refer to complete Model Number, Serial
Number and type of gas.
Notice:
smoke will occur. To prevent triggering of smoke alarms, ventilate
the room in which the unit is installed.
Page 6

INTRODUCTION

Installation on Rugs and Tile
If this appliance is installed directly on carpeting, tile or other
be installed on a metal or wood panel extending the full width and
depth of the appliance.
used on wood stoves. The protection is for rugs that are extremely
thick and light colored tile.
Installation and replacement of gas piping, gas utilization equipment
or accessories and repair and servicing of equipment shall be
person or through a representative is engaged in and is responsible for
HEATER OR ITS
installation, repair or servicing of equipment, who is experienced in
such work, familiar with all precautions required and has complied
with all the requirements of the authority having jurisdiction.
The installation must conform with local codes or, in the absence of
local codes, with the National Fuel Gas Code, ANSI Z223.1.*
*Available from the American National Standards Institute, Inc. 1430
Broadway, New York, N.Y. 10018.
High Altitudes
sea level. Contact the manufacturer or your gas company before
Well Head Gas Installations
Some natural gas utilities use "well head" gas. This may affect the
Btu output of the unit. Contact the gas company for the heating value.
Contact the manufacturer or your gas company before changing
Solid-fuels shall not be burned in a masonry or UL 127 factory-
State of Massachusetts: The installation must be made by
Massachusetts.
room heaters shall provide to each purchaser a copy of 527
CMR 30 upon sale of the unit.
In the Sate of Massachusetts, unvented propane and natural
bathrooms.
WARNING:
propane) gas. Field conversion is not permitted.
26497-6-0511