[Connection Example] - Panasonic WV-NP1004 Operating Instructions Manual

[Connection example]

When connecting with a PC directly
<Required cable>
LAN cable (category 5, cross)
When connecting via a network
AC24V
IN
1-L
2-N
GND
10BASE-T/
100BASE-TX
<Required hardware>
Switching hub or router
<Required cable>
LAN cable (category 5, straight)
Important:
• Use a switching hub or a router which is compliant with 10BASE-T/100BASE-TX.
• Power supply is required for each network camera.
• When connecting multiple network cameras, it is necessary to configure the settings of the router in use. It is also neces-
sary to configure port numbers for each network camera independently. Refer to page 21 for further information about the
settings.
Refer to the operating instructions of the router for descriptions of how to configure the router.
AC24V
IN
VIDEO OUT
1-L
POWER
2-N
SD CARD 1 GND
2 DAY/NIGHT IN
3 AUX OUT
4 ALARM OUT
LINK
5 ALARM IN
GND
1
2
10BASE-T/
3
100BASE-TX
4
5
ACT
LAN cable (category 5, cross)
VIDEO OUT
POWER
SD CARD 1 GND
2 DAY/NIGHT IN
3 AUX OUT
4 ALARM OUT
LINK
5 ALARM IN
1
2
3
4
5
ACT
Network device
(Hub, router, ADSL/CATV
modem, etc.)
LAN/Internet
PC
System device
Connect to the video input connector of a frame
switcher, matrix switcher, etc.
Video monitor
Note: When connecting to the
video input connector of a
device that has the power
switch for the connected
camera, such as the
Panasonic WV-CM142,
turn the power switch for
the connected camera off.
Recording device
Connect to the video input connector of a digital
disk recorder, time lapse VCR, etc.
PC (Refer to page 7 for the
system requirements for a PC)
15