Major Operating Controls And Their Functions - Panasonic WV-NP1004 Operating Instructions Manual

Major Operating Controls and Their Functions

Cover for the
operation buttons
<TOP>
Safety wire holder
<REAR>
Safety wire holder
AC 24 V terminal
SD memory card
error indicator (red)
10
Microphone
Inside the cover for the operation buttons
(Slide to the left until the cover is locked.)
INITIAL SET (UP)
NEAR ABF/MENU
(LEFT) (SET) (RIGHT)
(DOWN)
[INITIAL SET] button
• About the [INITIAL SET] button
Turn on the power of the camera while holding down this button, and wait for around 5 seconds without releasing
this button. Wait another 30 seconds after releasing the button. The settings including the network settings will be
initialized. However, the settings edited on the [Camera] tab of the "Camera setup" page will not be initialized.
SD memory card slot cover
Screw holes for the camera mounting bracket (1/4-20UNC)
AC24V
IN
VIDEO OUT
1-L
2-N
GND
10BASE-T/
100BASE-TX
Link indicator
Network connector
Tripod mount base
Operation buttons
* In these operating instructions, names of the buttons are as follows.
[UP] button
FAR
[DOWN] button
[LEFT/NEAR] button
[RIGHT/FAR] button
[SET, ABF/MENU] button
<BOTTOM>
Screw hole for the camera mounting bracket (1/4-20UNC)
Video out connector
POWER
Power indicator (green)
1 GND
SD CARD
2 DAY/NIGHT IN
3 AUX OUT
4 ALARM OUT
LINK
5 ALARM IN
1
2
3
External I/O terminals
4
5
ACT
Access indicator
Fixing screw for transportation
* Remove the fixing screw before
connecting the power cable.
ALC lens connector