Table of Contents
Advertisement
10). Using the Door Opening Tool provided with the Fireplace Insert, insert the
tool through the Outer Shell of the Fireplace Insert. You will be inserting this
tool through a keyhole on front edge of the Flue Collar Slide Plate.
Figure 3.2 Vent Connection
11). The Flue Collar Slide Plate needs to be engaged into the Slide Plate Retainers
as you pull it forward.
12). You will slowly slide the Fireplace Insert back into the Fireplace Cavity. At the
same time, you will be pulling the Flue Slide Plate forward onto the Fireplace
Insert.
** Be extremely careful that the Gasket between the Fireplace Insert and the
Flue Collar Slide Plate is not damaged and remains in the correct position.
Failure of this gasket will greatly diminish the operation of this appliance. **
13). Make certain that when the Flue Collar Slide Plate comes forward that the tab
at the back of the appliance engages into the Flue Collar Slide Plate. Without
this engagement, the Flue Collar Slide Plate will not seal against the Gasket
and the unit will not function.
Figure 3.2 Vent Slide plate
14). Once the Flue Collar Slide Plate is within 1" of the front, Use the 1/4" NC screw
supplied and secure the Flue Collar Slide Plate to the front of the Fireplace
Insert.
Figure 3.3 Secure Slide plate
XG0528 - 170223
Section 3: Installation
Door Installation & Removal
This appliance is supplied with a safety screen installed. The Safety
Screen is attached to the fireplace door using 4 screws, and can be
removed when necessary for outer glass cleaning.
The Fireplace Door is attached to the Firebox by way of 2 tabs mounted
to the top of the Firebox and by 2 spring loaded retainers at the
bottom underneath the Door. The Retainers at the bottom of the unit
are manipulated using a Door Tool that is supplied with the unit. The
general operation of the Door Retainers is:
a). Engage the Door Tool into the Door Retainer
b). Move the Door Tool to the left to release the Door Retainer
c). Move the retainer downward and then back underneath the Door
d). Swing the Door outward from the unit and then lift the Door up and over
the top Tabs
Engage door tool into door retainer. Push door tool left, disengaging
the door retainer from the door.
Engage door tool into door retainer. Pull door tool towards you and
push downwards, disengaging the door retainer from the door.
Figure 4.0 Door removal
Installation
11
Advertisement
Table of Contents
