Table of Contents
Advertisement
■ Entering the MMSI code
First, you must enter the 9 digit MMSI
(Maritime Mobile Service Identity: DSC
self ID) code at power ON.
NOTE: You can enter this initial code
ONLY ONCE. After entry, only your
dealer or distributor can change it.
If your MMSI code has already been
entered, this entry is not necessary.
1.
Hold down [ ] for 1 second to turn
ON the transceiver.
• Three short beeps sound.
• "Push [ENT] to Register Your MMSI" is
displayed.
2. Push [ENT] to enter the MMSI
code entry mode.
• Push [CLR] to cancel the entry. In that
case, the transceiver displays "Push
[ENT] to Register Your MMSI" again.
3. Enter your 9 digit MMSI code.
4.
After entering the 9th digit, push
[Finish]
to set the ID.
Push
5. Reenter your MMSI code to
confirm.
PREPARATION
6. After entering the 9th digit, push
[Finish]
Push
+
Rotate
• When you successfully enter your
MMSI code, the following screen is
displayed.
Push
Push
• After that, the Main screen is
displayed. The registered MMSI code
is displayed at the top of the screen.
+
Rotate
3
1
2
3
to register the ID.
4
5
6
7
8
Push
9
10
11
12
13
14
15
16
9
Advertisement
Table of Contents
