Floor Mount Anti-tip Installation
3
x2
Remove two screws from back of range.
Connecting Gas & Electric
5
according to the manufacturer's
instructions. Before placing appliance in
operation, always check for gas leaks
with soapy water solution.
Slide range into place and check that hook
and bracket are engaged.
Note: Refer to electrical and gas
requirements section for proper
installation information.
Connect gas and electrical. Before placing appliance in operation,
always check for gas leaks. This must be performed by your
dealer, a qualified licensed plumber, or gas service company.
22
(cont.)
4
Attach bracket to back of range using two screws.
DANGER
To avoid risk of personal injury
or death; leak testing of the
appliance must be conducted
1
Final Installation
1
Slide range into place. Be sure
anti-tip bracket slides into the anti-tip opening.
cardboard top pack with the grates. Align burner head
3
"
"
"
3 / 8
3 / 8
3 / 8
)
)
)
c m
c m
c m
9 5
9 5
9 5
( 0 .
( 0 .
( 0 .
Check that unit is level side to side
and front to back. The side trim must be 3/8" (0.95 cm)
above countertop. If unit is not level repeat Steps 5-7
of "Leveling/Adjustments/Alignment" section.
23
2
Burner heads and burner caps are packed in the
on burner base. Place burner cap on burner head.
Place grate onto the burner pan.