Subaru H001SFJ800 Installation Manual page 30

Check E
The door was opened
but engine did not stop.
Yes
Please check +B, GND, IG using the wiring harness checks (page 34). Was the problem solved?
No
Replace the SES ECU and register again. If registration fails, replace the SES wiring harness.
Close the all doors, press the Unlock and then the Lock button on the car's remote. Do the doors
lock and hazard lights work correctly?
Yes
Check the vehicle using the Subaru SSM. Are there any problems found?
No
Contact Subaru for additional troubleshooting
information.
No
Press the "ENGINE START STOP" Button to stop engine.
Refer to wiring harness checks on page 34, check +B, GND, IG. Was problem solved?
No
Replace SES ECU and register again. If Registration fails again, replace the SES Wiring Harness.
In which case does the engine won't stop?
The lock button was pushed and held more than
Open a door, does the engine stop?
Press the "ENGINE START STOP" Button to stop the engine.
See the car's repair manual. Check the remote's battery
might have run out.
Open the hood. Did the engine stop?
- 30 -
2 seconds, but engine did not stop.
No
Yes
Troubleshooting completed.
No
Yes
Fix the vehicle problem first.
Yes
Failure of the courtesy signal system.