Table of Contents
Advertisement
Special Mounting Plates (Limit Switches are not attached to the Plates.)
D4C-P001 (For D4CC-@001)
D4C-P002 (For D4CC-@002)
D4C-P020 (For D4CC-@024)
Note: Unless otherwise specified, a tolerance of ±0.4 mm applies to all dimensions.
Remarks
There is no difference in mounting pitch between the Mounting Plate
and the WL. The mounting depth of the D4CC with the Mounting Plate
attached is, however, shorter than that of the panel-mounted WL.
http://www.ia.omron.com/
±
25
0.2
15.7
7
34
(OP of WLD)
18.3
±
58.7
0.2
30
34.1
4-2R
±
30.2
0.2
44
±
25
0.2
28.5
44
9.5
(OP of WLD2)
15.5
±
58.7
0.2
30
34.1
±
4-2R
0.2
30.2
44
±
25
0.1
+0.12
Two, 4
dia.
0
(for positioning),
into which a spring
pin is press-fitted.
±
5
0.2
14.7
±
9.2
0.2
30
34.1
±
58.7
0.2
75
4-2R
±
30.2
0.2
44
13.1
Two, M5 × 0.8
tapped hole *2
5.1
95
1.3
11 dia.
+0.2
Four, 5.2
dia. holes *1
0
13.1
5.1
Two, M5 × 0.8
tapped hole *2
95
1.3
11 dia.
+0.2
Four, 5.2
dia. holes *1
0
±
53
1.5
±
9
0.2
Two, M5 × 0.8
tapped hole *2
11 dia.
1.3
+0.2
Four, 5.2
dia. holes *1
0
(c)Copyright OMRON Corporation 2007 All Rights Reserved.
D4CC
±
0.2
Note: Four hexagonal flat head bolts
(M5 × 0.8, length: 10) and two
Allen-head bolts (M5 × 0.8,
length: 15) are included.
+0.2
*1. All the holes with 5.2
dia. must be used
0
with M5 × 10 Allen-head bolts.
*2. All the M5-tapped holes must be used with M5
hexagonal flat head bolts.
±
0.2
Note: Four hexagonal flat head bolts
(M5 × 0.8, length: 10) and two
Allen-head bolts (M5 × 0.8,
length: 15) are included.
+0.2
*1. All the holes with 5.2
dia. must be used
0
with M5 × 10 Allen-head bolts.
*2. All the M5-tapped holes must be used with M5
hexagonal flat head bolts.
Note: Four hexagonal flat head bolts
(M5 × 0.8, length: 10), two
Allen-head bolts (M5 × 0.8,
length: 15), and two spring
pins (4 × 14) are included.
+0.2
*1. All the holes with 5.2
dia. must be used
0
with M5 × 10 Allen-head bolts.
*2. All the M5-tapped holes must be used with M5
hexagonal flat head bolts.
6
Advertisement
Table of Contents
