Omron D4CC-1001 Manual page 3

Structure and Nomenclature
Structure
Center Roller Lever Models with Indicator
O-ring
(NBR)
Nitrile rubber
diaphragm
Protective nitrile
rubber cap (NBR)
Open space (to reduce
a change in internal
pneumatic pressure and to
prevent the respiratory
movement of the Switch.)
LED indicator
Connector
receptacle
Contact Form
AC Switches (D4CC-10@@, 20@@)
Without Operation Indicator
Pin No.1 COM
With Operation Indicator (Lit when Not Actuated) *1
Pin No.1 COM
*1. "Lit when not actuated" means that when the actuator is in the free position, the indicator is lit, and when the actuator is turned or pushed and the contact comes
into contact with the NO side, the indicator turns OFF.
*2. The position of the positioning piece is not always the same. If using an L-shaped connector causes problems in application, use a straight connector.
Connections
Note: Colors in parentheses are the previous wire colors. Wire colors have been changed accompanying changes in standards.
For AC
Pin No.
http://www.ia.omron.com/
Roller
Center lever
Spacer
prevents the Switch from biting cut chips.
O-ring (NBR)
Built-in switch
Ground terminal
Molded resin
NC Pin No.2
NO Pin No.4
E
NC Pin No.2
NO Pin No.4
E
150 kΩ
Positioning
piece *2
Plug
Cable
Brown (Red)
White (Orange)
Blue (Black)
Black (White)
DC Switches (D4CC-30@@, 40@@)
Without Operation Indicator
Pin No.1 COM
With Operation Indicator (Lit when Not Actuated) *1
Pin No.1 COM
For DC
Plug
Pin No.
(c)Copyright OMRON Corporation 2007 All Rights Reserved.
D4CC
NC Pin No.2
NO Pin No.4
E
NC Pin No.2
NO Pin No.4
E
30 kΩ
Positioning
piece *2
Cable
Brown (Red)
White (Orange)
Blue (Black)
Black (White)
3