Table of Contents
Advertisement
Chapter 6 Troubleshooting
If a problem still remains after applying the suggested remedies, contact your local EIZO representative.
6-1. No picture
Problem
1. No picture
• Power indicator does not light
• Power indicator is lighting blue
• Power indicator is lighting orange
• Power indicator is flashing orange
Possible cause and remedy
• Check whether the power cord is connected properly.
• Turn the main power switch on.
• Press
.
• Turn off the main power, and then turn it on again a few
minutes later.
• Increase "Brightness", "Contrast", or "Gain" in the Setting
menu (see
"To perform advanced adjustments" (page
10)).
• Switch the input signal with
• Move the mouse or press any key on the keyboard.
• Touch the panel surface.
• Check whether the PC is turned on.
• Depending on the PC and graphics board, the input signal
is not detected and the monitor does not recover from
the power saving mode. If the screen is not displayed
even after moving the mouse or pressing any key on the
keyboard, turn the monitor off and on using its power
button. When the screen is displayed, execute the
following procedure. The problem may be improved.
1.
Press
to turn off the monitor.
2.
Hold down
monitor.
"x" is displayed on the menu title of "Information"
of the Setting menu (see
Information" (page
3.
Reboot the PC.
To return to the previous setting, perform steps 1 to
3 again.
• The device that is connected using DisplayPort have a
problem. Solve the problem, turn off the monitor, and then
turn it on again. Refer to the User's Manual of the output
device for further details.
.
while pressing
to turn on the
"7-3. Displaying Monitor
35)).
Chapter 6 Troubleshooting
27
Advertisement
Table of Contents
