MULTIQUIP LT6k Operation Manual page 21

12
12. Lights— Four 1000-watt metal-halide bulbs with a
110,000 lumens capacity each. Light coverage is
typically between 5 to 7 acres.
13. Cradle Lock/Release pin — Locks mast in cradle
support and releases mast when removed.
14. mast Cradle support — When towing of the light tower
is required, place the tower mast into the cradle support.
Make sure cradle lock/release pin has been inserted
and mast is locked.
15. Forklift Pockets — The light tower can be lifted by
inserting the forks of a forklift as far possible into the
pockets.
16. D-Ring Lifting Point — Attach a suitable lifting device
to this lifting point capable of lifting 2000 lbs. (257
kg). The D-ring lifting point has been positioned for a
fully balanced/configured light tower. Removal of any
components will unbalance the light tower.
17. mast extensionWinch — Use this winch to extend the
mast to the desired height. Maximum height is 31.5 feet
(9.60 meters).
LT6K LIgHT TOWeR • OpeRaTIOn manuaL — Rev. 2 (09/11/14) — page 21
14
13
3
Figure 4. Major Components 2 (Fuel Fill Side)
17
16 18
15 15
20
23
18. mast Rotation Locking Knob — Unscrew this knob to
release mast for rotation. Tighten this knob to lock mast
after it is set to the desired position.
19. vertical mastWinch — Use this winch to raise the mast
to the vertical position.
20. FuelTank/Cap — Remove cap to add Low Sulfur No. 2
diesel fuel. Fuel tank capacity is 34 gallons (103.6 liters).
21. mast Lock/Release Lever — When the mast is in the
full vertical position, this lever must be in the locked
position (down).To place the mast in the stow position,
pull the lever upward to release the mast.
22. safety Chain — Always attach safety chains to the
towing vehicle. neveR tow the light tower with the safety
chain unattached. Make sure safety chains are crossed
when towing.
23. Battery — The 12-volt DC batter y (CA:550/
CCA:430) is shipped wet and is ready for use.
Battery is shown here for clarity.
components
19
3
21
22