MULTIQUIP LT6k Operation Manual page 40

Light tower/generator
Table of Contents

Advertisement

Lamp Replacement
NOTICE
If a light (lamp) replacement is required, allow lamp to
cool for about 30 minutes before removing lamp. DO
nOT touch lamp with your hands.
The oil and perspiration from one fingerprint may cause
the lamp to fail prematurely. ALWAYS use a clean dry
cloth for cleaning or handling lamps
1. Place all circuit breakers in the OFF position.
2. Remove protective lens and rubber gasket from lamp
housing.
3. Remove defective lamp from housing.
4. Install new lamp, be careful not to touch lamp surface
with your hands.
5. Reinstall protective lens and rubber gasket.
Radiator Cap access
1. Remove the four bolts that secure the radiator cap
access cover (Figure 30) to the rear cabinet. Remove
access cover and gasket.
2. Reach inside access opening and remove radiator
cap. Allow engine to cool before removing cap. The
possibility of hot coolant exists which can cause severe
burns.
RADIATOR CAP
ACCESS COVER
(REMOVE)
REAR
CABINET
BOLTS
Figure 30. Radiator Cap Removal
page 40 — LT6K LIgHT TOWeR • OpeRaTIOn manuaL — Rev. #2 (09/11/14)
RADIATOR CAP
REMOVAL
Filling The Radiator
1. Remove the black plastic plug (Figure 31) on the top
of the cabinet just above the radiator cap access hole
opening.
CABINET
TOP
FUNNEL
Figure 31. Adding Coolant
2. Next, insert a funnel through this opening into the
radiator fill port.
3. Add coolant as required.
4. Reinstall black plastic access plug on top of cabinet
and also reinstall radiator cap access cover back onto
rear cabinet.
FLusHIng OuT RadIaTOR and CHangIng
COOLanT
WaRnIng
Allow engine to cool when flushing out
radiator. Flushing the radiator while hot will
damage radiator. In addition, the possibility
of hot coolant exists which can cause
severe burns.
1. Stop the engine and allow it to cool. Tighten valve of
the corrosion resistor (if equipped).
2. Turn water filler cap slowly and remove it.
3. Prepare a container to catch the coolant, then open
drain plug of the radiator or heat exchanger and drain
plug of the engine, and drain the coolant.
maintenance
RADIATOR
CAP
BLACK
ACCESS
PLUG
RADIATOR
FILL PORT

Advertisement

Table of Contents
loading

Table of Contents