End The Operation And Stop The System - JRC JMR-611 Instruction Manual

3.1.4 End the Operation and Stop the System

Exit 1
2
When conducting maintenance work, make sure to turn off the power and
unplug the power line of the processor so that the power supply to the
equipment is completely cut off.
Some equipment components can carry electrical current even after the
power switch is turned off and conducting maintenance work without
unplugging the power connector may result in electrocution, equipment
failure, or accidents.
Press [STBY] key.
The radar will stop transmission and the antenna will stop rotating.
Transmit at lower left of the screen changes to
Maintain the standby state if radar observation is restarted in a relatively short time.
Only pressing the [TX] key starts observation.
Press the [STBY] key and the [TX] key together.
The system will be turned off.
Standby .
3-4