Screen Capture Setting (Capture Mode); Screen Capture Setting (Auto Capture Interval) - JRC JMR-611 Instruction Manual

3.7.4 Screen Capture Setting (Capture Mode)

There are four modes in screen capture function.
Off
Manual : Manual mode. In this mode, screen capture data is saved in a flash memory card
Auto-1 : In this mode, screen capture data is saved in a flash memory card automatically with
Auto-2 : In this mode, screen capture data is saved in an internal memory automatically with
Note: Please don't remove the flash memory card in "Auto-1" mode. Because you can not know when
the system saves data in the card. Before remove the card, turn off the system or set this setting
to off, Manual, or Auto-2.
Procedures 1
2 Select 4.Capture Mode and press [ENTER] key.

3.7.5 Screen Capture Setting (AUTO Capture Interval)

This setting is to determine the interval in Auot-1 or Auto-2 mode.
Procedures 1
2 Select 5.AUTO Capture Interval and press [ENTER] key.
3 Input interval time and press [ENTER] key.
: Capture function is off.
whenever the key (refer to Fig2.2-18) on the operational unit or button on the screen
(refer to Fig2.3-20) is pressed.
the interval which is set in 5.AUTO Capture Interval .
the interval which is set in 5.AUTO Capture Interval . This data is deleted when this
system is turned off. Therefore, moving the data from internal memory to a flash
memory card is necessary. (Refer to 3.7.2)
The captured data in internal memory can be saved from internal memory to a flash
memory card whenever the key (refer to Fig2.2-18) on the operational unit or button
on the screen (refer to Fig2.3-20) is pressed.
Press [MENU] key.
Select 8.Next and press [ENTER] key.
Select 1.Screen Capture Setting and press [ENTER] key.
Press [MENU] key.
Select 8.Next and press [ENTER] key.
Select 1.Screen Capture Setting and press [ENTER] key.
Auto-1 mode : 1-999min
Auto-2 mode : 15-999sec
3-48